Aeroneb GO Micropump Handset Assembly
This is the NEW Twist-On version of the Aeroneb GO micropump handset.
If you purchased an Aeroneb GO model 7090 after January 1, 2013 that has a Twist-On top for the handset, this is the correct replacement item.
If you have the older snap together micropump handset you will need to purchase a new DC cable in order to use this new twist-on microump handset as the old DC cable will not work with the new style handset. - See the notice stated below for a link to the new DC cable.
There are two primary differences between the old style and the new style:
1. The new style has a Twist-On top - the old style has a snap together top.
2. The new style uses a slightly different connector at the "gold pin" end. Because of this change the old wire will not work in the new handset.
This new handset will function with any of the battery controllers used with the Aeroneb Go.
IMPORTANT - This handset requires using the NEW DC cable part number 7090-02 (AG-AG4070) you can not use the old style DC cable part number 22201 with this handset.
This handset will NOT work with the old style direct connect AC power supply.
Cross reference part number: EVO Medical & Drive Medical 7090-01
READ BELOW BEFORE YOU ORDER!!
Please make sure you have the correct connection cable for this part. You can order it at this link 7090-02 (AG-AG4070) DC Cable for NEW Twist On Micropump. This is the ONLY cable that will work with this HandSet!